The connection of ChromaHead to the Tool section of your existing 3D printer consists of two components. One of these components is connected to the rear of ChromaPad. The other part should be connected to the Tool section of your 3D printer. Please note that the design of this component may vary for different types of 3D printers.
Place the necessary component into the Tool section of your 3D printer. Attach ChromaHead to the groove on this component.
Tighten the two screws on the right and left sides, and connect the ribbon cable that was provided with ChromaHead to either your ChromaHead and ChromaPad or KCM.
You are now ready.