ΒΆ bed_screw Definition
This guide has been prepared to help you troubleshoot the error you may receive when performing manual leveling via ChromaPad.
The reason for this error is that the bed_screw definition is commented out in cp_macro. If you remove it from the comment as shown below and adjust it according to your printer's table size, you will be able to do manual leveling without any problems.
- Enter the ChromaPad IP address into your browser and enter Mainsail.
- Enter the "machine" section on the left bar.
- Open cp_macro.cfg
- Uncomment the [bed_screw] line there and adjust it according to the size of the table.
- Save and exit by doing save&restart.
